The chlorine concentration detector is used to detect and provide early warning of dangerous (toxic) concentrations. The E2608-CL2 detectors are designed for detecting hazardous chlorine concentrations in swimming pools, spas, wellness centres and other facilities. The DM version allows the sensor to be installed directly in the HVAC duct. 

Chlorine is heavier than air. Therefore, chlorine detectors should be mounted approximately 15 cm above the floor. When used in HVAC ducting, the sensor is installed directly in the airflow.

The EVIKON E2608-CL2 detector is equipped with two-stage signalling with outputs to switching relays. It does not have its own visual or audible alarm. The E2608 series detectors are an intelligent solution for modern applications with ModBus RS485 communication and two analogue outputs 4-20mA/0-10V.

The sensor can be ordered in the following versions:

• wall-mounted (in stock)
• for HVAC duct installation (on request)
• with cable probe (on request)

Manufactured in a robust design with IP65 protection rating - ABS plastic, resistant to mechanical damage. Rigid, tough, resistant to both low and high temperatures, low absorbency, and safe for health. Specified sensor service life (2 years).

Each sensor is factory-calibrated to default values (described in the manual). The law stipulates that recalibration must be carried out at least once every 12 months. Calibration may only be performed by a person certified by the manufacturer.

Do not hesitate to contact us for recalibration!

The sensor is intended for chlorine detection:
CL2

Features:

• Selective, sensitive and stable detection
• Wall mounting, duct mounting, remote probe, IP65 protection
• Two output relays for alarm / ventilation control
• Two analogue outputs 4-20mA/0-10V
• ModBus RS485 digital communication

Tip: Get automatic reminders of the statutory calibration date via the service www.kalibrovat.cz