The submersible sewage pump with float Wilo TM32/7 is an indispensable assistant for pumping water in domestic conditions. The pump is ready for fully automated operation. It is lightweight and easy to carry, suitable for both fixed and mobile installation. For water discharge, a pressure hose or pipe can be used (especially for permanent placement).

The motor is cooled by the surrounding medium, transferring its residual heat to the surroundings through its casing. In case of overheating, the pump switches off and restarts once it cools down. The hydraulics are separated from the motor by a sealing chamber filled with white oil. On the motor side, there is a shaft sealing ring, and on the hydraulic side, a mechanical seal.

Application of the Pump

Pumping clean or slightly contaminated water:

• from tanks, shafts, and excavations
• during flooding and inundation
• from sumps
• for drainage of basement areas
• water without faeces and components with long fibres

Features and Equipment of the Pump

• float switch (factory-installed)
• 4 m connecting cable incl. "Schuko" plug
• cooling by casing flow
• IP68
• thermal motor control
• temperature of the pumped medium is +3...+35 °C (short-term up to 3 minutes, medium can be pumped up to a temperature of 90 °C)
• max. submersion depth 1 m
• discharge outlet Rp 1 1/4 (internal thread DN32).

Contents of Delivery

• pump
• cable with plug
• installed float switch
• threaded connection with check valve
• hose connection
• installation and operating instructions