The submersible sewage pump with float Wilo TM32/8 is an indispensable assistant for pumping water in domestic conditions. The pump is ready for fully automated operation. It is lightweight and easy to transport, suitable for both fixed and mobile installation. For water discharge, a pressure hose or pipe can be used (especially for permanent placement).

The motor is cooled by the surrounding medium, transferring its residual heat to the surroundings through its casing. In case of overheating, the pump switches off and restarts after cooling down. The hydraulics are separated from the motor by a sealing chamber filled with white oil. On the motor side, there is a shaft sealing ring, and on the hydraulics side, a mechanical seal.

Use of the Pump

Pumping clean or slightly contaminated water:

• from tanks, shafts, and excavations
• during flooding and inundation
• from sumps
• for drainage of basement areas
• water without faeces and components with long fibres

Features and Equipment of the Pump

• float switch (factory-installed)
• 8 m connecting cable incl. "Schuko" plug
• cooling by casing flow
• IP68
• thermal motor control
• temperature of the pumped medium is +3...+35 °C (short-term up to 3 minutes, medium can be pumped up to a temperature of 90 °C)
• max. immersion depth 1 m
• discharge outlet Rp 1 1/4 (internal thread DN32).

Delivery Contents

• pump
• cable with plug
• installed float switch
• threaded connection with non-return valve
• hose connection
• installation and operating instructions